欧冠热门

Welcome to Taizhou Hongying Mechanical Equipment Manufacturing Factory official web!
Products
Fuel/air duct expansion joint

Model:

Metal Compensator series

Temperature:

0℃

Material:

upon your demands

Pressure:

0Mpa

Details:

Smoke wind pipe Metal Compensator, Corrugated expansion joints, pipe expansion joint in U.S. EJMA professional design software, optimization design, YFB type smoke wind pipe expansion joint/pipe slip joint can absorb the axial displacement, arbitrary to lateral displacement. Pipe expansion joint/piping expansion joints have high temperature resistant, long service life, etc.

欧冠热门Installation requirements

Before the installation, should check the Corrugated Compensator Model, specification and pipe support configuration must meet the design requirements.

With lining Compensator, attention should be paid to make the lining tube direction is consistent with the flow direction of medium (according to the flow of Compensator sign installation). Plane Angle to flow the Hinge type Compensator plane should be consistent in plane displacement.

欧冠热门Need to be "cold" tight Compensator, the prestressing of auxiliary components, should be dismantled in the piping system after the installation.

欧冠热门Piping installation shall be immediately removed Compensator used to install auxiliary transport protection positioning and firmware, and according to the requirements of design limit device will be dispatched to the location of the regulations, make the piping have ample compensation ability under the environmental conditions.

In addition to the design requirements and tension and compression and deformation or cold "tight", it is forbidden to use the method of Corrugated pipe deformation of pipe to adjust deviation. So as not to affect the normal function of the Compensator, reduce the service life and increase the piping, equipment to take over and load of support components.

欧冠热门Compensator all the activities of the original may not be jammed or limit the activities of external components to work normally.

The installation process does not allow welding slag splash into the Corrugated tube surface and make Corrugated pipe by other mechanical damage.

欧冠热门For gas medium Compensator and connection pipe, make the water pressure experiment, whether you need to consider when water filling of Compensator to examine.

Water pressure test with water must be clean, no corrosion, and control the content of chloride ions in the water is not more than 25 PPM. After the water pressure experiment, as soon as possible to the best of water in the Corrugated, and promptly put the inner surface of the wave shell blow dry.

 
宏颖客服
 
 
 
 
河北快3 500万彩票 广西11选5 云南11选5 云南11选5 云南11选5 福建11选5 福建11选5